Car Alarms: Security On/Off Alarm/Chipper, toyota 4runner 4x4, valet mode

Question
I have a 98 Toyota 4Runner 4X4 A/Trans 6cyl.  My security "beeper" quit working quite awhile ago.  Parts folks said fix would be many $$'s.  I assume the relay went out -- yes I'm very familiar with the results of assuming .  My lights still blink when I arm/disarm the system -- but no "chirp."  Where can I find a replacement and/or the part number?

Answer
It appears from your expaination, that the
car alarm is in service mode.

Ok, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, press and hold in the valet/overide
button, found under the dash area, usually to the
left of the leg drilled into a hidden away spot,
until the installed LED (the blinking light)
in your dash area goes off, and the siren chirps twice.
(Your valet switch might be the toggle (on/off) type.
in this case, key on, flip switch in oposite direction,
key off.)

This should reset the alarm.

Just Repeat these steps to place it
back to valet mode.

That should do it.
Let me know what happens.

ALARMTEK
INSTALLSUPPORT.COM