Car Alarms: jeep xj immobiliser, valet mode, jeep cherokee

Question
When I try to start my jeep I have to push the key in really hard and then turn to start, (If I just turn the key it doesnt turn over) once started the lights start flashing. is there a way I can remove the immobiliser??
I have a right hand drive jeep cherokee 94, im not sure if its a standard immobiliser.
Thanks

Answer
It's an after market system
from your description.

To simply disarm it, locate and use the
valet/overide switch.

To start, look under the dash area for a button or,
a toggle switch. When you locate it, turn on the
ignition key, press and hold in the button (little
spring loaded micro button, red or black possibly)
until the alarm chirps 1 time. This should over ride
the system, and only the keyless entry part,
if installed, would still be operating.
The LED (light emiting diode) light in the dash
should also go on solid.=VALET/OVERIDE

This stops the alarm except for the keyless
entry if installed. The next step is to
either remove the alarm or, try to identify,
and get new remotes for it.

But once in Valet mode, it will allow the car
to start and operate like there was no
alarm at all. Repeat steps to put into user
mode.

Let me know how it goes.

ALARMTEK
CARALARMMAN.COM