Car Alarms: alarm not chirping when set, valet mode, dash area

Question
I own a 2000 Toyota Tacoma, untill recently when I set alarm or unlocked it a chirp would sound to confirm. Lately I no longer get the chip. Horn has checked out fine. Thank you in advance for any help... pfs

Answer
Should be no problem really.
It appears from your expaination, that the
car alarm is in service mode.

Ok, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, press and hold in the valet/overide
button, found under the dash area, usually to the
left of the leg drilled into a hidden away spot,
until the installed LED (the blinking light)
in your dash area goes off, and the siren chirps twice.
(Your valet switch might be the toggle (on/off) type.
in this case, key on, flip switch in oposite direction,
key off.)

This should reset the alarm.

Just Repeat these steps to place it
back to valet mode.

That should do it.
Let me know what happens.

ALARMTEK
INSTALLSUPPORT.COM