Car Alarms: Car alarm, hyuandi, alarmtek

Question
How can I dismantle a Hyuandi Elenatra 2002 car alarm.
I do not use remote access only my key.  However the alarm periodically goes off.  I would like to disarm, perhaps remove the fuse.  I do not know what fuse it is

Thanks!


Answer
Sorry, no factory alarm in the 02 Elantra.
Not sure what aftermarket system you have
there, but this should help.

Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, locate, press and hold in the
valet/overide button, found under the
dash area, (push button, spring loaded)
until the installed LED (the blinking light)
in your dash area goes on solid,
and the siren chirps once.

(Your valet switch might be the toggle
(on/off) type. in this case, key on,
flip switch in opposite direction,
then turn the key off.)

This should reset the alarm, and reset
the grounded relay on the starter wire,
allowing you to start the engine.

At this point, the only thing working would
be the keyless entry from the alarm,
if it came equipped that way.

Just Repeat these steps to place it
back to usable armed mode.
You may get 2 chirps, confirming it,
and the lights may flash twice as well.

That should do it.

Let me know what happens.

Robert Martin/CEO-ALARMTEK
DELUXESERVICE.com