Car Alarms: Code Alarm Not Confirming when activated, code alarm ca670, valet mode

Question
hello i have another question on code alarm ca670. a few things, well when i activarte the alarm, it should @l least do a chip on the speaker and flash the light. well the lights flash but i get no sound of the speaker confirming my alarm has been deactivate/activated.

onother thing is that i have a 2 way remote and when my alarm is goign off. the remote will not beep alerting me that my alarm is going on. now to my understanding , i believe it suppost to do that. also , the remote shous that my alarm is diactivate it when its really not. so im not sure if u can help me on this but i figure ill give it a try, thank you very much in advance.../


Answer
Ok, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, press and hold in the valet/overide
button, found under the dash area,
until the installed LED (the blinking light)
in your dash area goes off, and the siren chirps twice.
(Your valet switch might be the toggle (on/off) type.
in this case, key on, flip switch in oposite direction,
key off.)

This should reset the alarm.

Just Repeat these steps to place it
back to valet mode.

That should do it.
If you want to remove it at this point,
take it to your neighborhood installer
for this, or buy the wiring chart for
the vehicle, and reverse engineer it wire
by wire, until it's safely removed.

If it does not work out this way, you will have
to replace the system with one you know how
to operate and what to expect.

Let me know what happens.

ALARMTEK.