Car Alarms: 1993 grand cherokee limited not starting, alarmtek, dash area

Question
new battery, took to the auto shop, they said it was the alarm system, said they re-wired it, this was 4 days ago. It was starting fine. Now it's not starting again all lights and radio come on when key is turned. The car just wont start and it's not making any noise when trying to start. Auto shop I took it to said the starter fine, new battery, but security light on dash blinlking when trying to start it. What do you think is the problem?

Answer
The alarm seems to be doing it's job.
At least we know it's installed correctly
which is actually a good thing here.

Ok, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, locate, press and hold in the
valet/overide button, found under the
dash area, (push button, spring loaded)
until the installed LED (the blinking light)
in your dash area goes on solid,
and the siren chirps once.

(Your valet switch might be the toggle
(on/off) type. in this case, key on,
flip switch in opposite direction,
then turn the key off.)

This should reset the alarm, and reset
the grounded relay on the starter wire,
allowing you to start the engine.

At this point, the only thing working would
be the keyless entry from the alarm,
if it came equipped that way.

Just Repeat these steps to place it
back to usable armed mode.
You may get 2 chirps, confirming it,
and the lights may flash twice as well.

That should do it.
If you want to remove it at this point,
take it to your neighborhood installer
for this, or buy the wiring chart
(Go to: www.vehiclewires.com)
for the vehicle, and reverse engineer it wire
by wire, until safely removed.

If it does not work out this way,
you will have to replace the system
with one you know how to operate
and what to expect. Don't want to
get stuck in another bad situation.

Let me know what happens.

Robert Martin/CEO-ALARMTEK
www.CARALARMINSTALLER.com