Car Alarms: reset or disarmed viper car alarm, viper car alarm, dodge conversion van

Question
i installed new car battery and terminal clamps,car won't start alarm goes off remote won't turn off alarm has fresh battery also car has start kill. how do i get car to start again 1996 dodge conversion van

Answer
Ok, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, press and hold in the valet/overide
button, found under the dash area,
until the installed LED (the blinking light)
in your dash area goes on solid, and the siren chirps once.
(Your valet switch might be the toggle (on/off) type.
in this case, key on, flip switch in opposite direction,
key off.)

This should reset the alarm, and reset
the grounded relay on the starter wire,
allowing you to start it. At this point,
the only thing working would be
keyless entry from the alarm,
if it came equipped.

Just Repeat these steps to place it
back to usable armed mode.

That should do it.
If you want to remove it at this point,
take it to your neighborhood installer
for this, or buy the wiring chart (www.wirewerx.com)
for the vehicle, and reverse engineer it wire
by wire, until safely removed.

If it does not work out this way,
you will have to replace the system
with one you know how to operate
and what to expect. Don't want to
get stuck in another bad situation.

Let me know what happens.

ALARMTEK
CARALARMSTORE.com