Car Alarms: programming the remote, side kick panel, fuse box


Question
I bought a 90 Chev Lumina 3.1 (car) off of a friend. My brake lights went out so I checked the usual stuff, fuses, lights. I noticed a Crimestopper RS-775 remote starter under the dash. I ordered the remote and it came with programming instructions, but I'll be darned if I can get this to work. I have installed Bulldogs, and AutoCommands, and even a Black Widow once, so I do have some experience with these things. I did notice the brakelight wire from the module was connected to a light blue wire going under the pass. side kick panel. It looks like it goes to the rear of the car!? I am getting power at the fuse box also.(For the brakes that is!). I followed the programming istr., but no good. Please help!
Thanks in advance.
Robert Beam

Answer
Wish I could but if they're own instructions
do not work, I'd have to tell you to
call them directly for answers on they're
equippment.

Normally, to program remotes, it's a series of
ignition turns, and valet button presses, on top
of using the lock button on the remote, to set it.

Contact the folks at Crimestopper.
That should go faster.

Good luck with it.

ALARMTEK
UScaralarms.com