Audio Systems: exposing the radio, kenwood cd player, buick lesabre

Question
I am trying to install a kenwood cd player in my 92 Buick LeSabre. I have pretty much hit a brick wall because i cannot get the front panel off without breaking the plastic that holds it in place. I figure that there must be some way to remove it from behind it, but I do not know how to take it off without breaking it. If you have any idea how i would do this, your help would be appreciated.  

Answer
Mark,

  no problem here is the steps .. just make sure you have a wire harness adapter to make your install wiring easier

take out 2 screws from the top underside of the instrument bezel
remove trim below the dash bezel on the left and right sidesof the steering wheel by carefully prying outward with a small screwdriver to release the pop clips
remove 8 screws located behind the trim that secures the dash trim and lower section of the glove box
remove 4 dash vents by pulling them outward and removing the single screw in each
open the glove box and take out the screws from each top corner and remove the glove box
remove dash trim panel extract 5 screws that secure sthe radio

hope this helps you out if you need anything else let me know

thanks