QuestionHi
Helping a friend sell her '02 T&C Van -- Odometer works but speedometer doesn't move at all. (Can't be registered to new owner with speedometer not working.) She says that it has been this way for nearly a year. Read the comments re: an '01 -- any thing else of note on the '02...?
Thanks,
-- Jim
AnswerHi Jim,
The following is from the '02 manual:
Have you tried the cluster fault code and calibration procedure?
With the key off, press and hold the odometer reset button,
Turn the key to the 'run' position and continuing holding the reset button until Sof appears in the odo window
Then release the button and wait.
See if any numbers that are 4 digit appear in the odo window. Then watch the cluster to do a calibration test; The first test should be that the speedo should shouw 0, 20, 60, 100 then other units will be tested. If the speedo doesn't respond then check that fuse 24 is good, and you could verify that 12v from that fuse is appearing on pin 6 of the cluster plug and that pim 13 of the plug is grounded. If all that is true, then the cluster needs to be replaced.
One other possibility would be to open the cluster and examine the circuit board in the area where the speedo is located, identify a couple of solder joints associated with the speedo and reheat those with a soldering pencil as one of them might by a 'cold/cracked' joint.
Let me know if you get any code numbers on the odometer.
Please read the PS (below) and respond to it.
Thanks,
Roland
