QuestionQUESTION: 2001 chrysler town and country 3.3 engine
driving down the road one night and car stalled. have already changed the fuel pump, fuel filter, spark plugs and wires. The car won't start....I was getting a MAP sensor code which was also replaced. Car started and ran the other day for a few minutes after fiddeling with the relay sensors. turned off car and tried to start it again and it would not start. still wont start. what else should i be checking
ANSWER: what were the map sensor codes?
---------- FOLLOW-UP ----------
QUESTION: the MAP sensor code was P0106
ANSWER: are u planing on fixing this or have some one do it? why I ask there is more then likely a wire issue and I can tell u about it but its not just a pop on and off sorta thing.
---------- FOLLOW-UP ----------
QUESTION: I am doing this myself......I have already replaced the MAP sensor and looked at the wiring harness and everything there tested ok. yes please tell me what you are thinking! Getting very frustrated that my car won't work and I can't seem to find the exact problem!
Answerthe coil pack on the driver side of the engine look behind it around the engine valve cover U will find a connector with 14 wires in it open up the wire harness with the tape on it U might find some wire melted together from water or oil being inside the tape U can get a replacement connector from a Chrysler dealer it is C103 I think
