QuestionQUESTION: 2003 chrysler concorde how do i get a good descrption of re and re of power steering pump on my chrysler.thanks
ANSWER: engine size?
---------- FOLLOW-UP ----------
QUESTION: engine size 3.5
AnswerREMOVAL - PUMP (3.5L ENGINE)
Remove the battery ground cable from the ground stud on the shock tower and isolate the ground cable by installing the cable isolator on the ground stud (Correctly Isolated Remote Ground Cable).
NOTE: The following step should be done to prevent excessive spilling of power steering fluid when the power steering fluid lines are removed from the power steering pump.
Using a siphon pump, remove as much power steering fluid as possible from the power steering fluid reservoir.
Raise vehicle. (Refer to LUBRICATION & MAINTENANCE/HOISTING - STANDARD PROCEDURE)
Remove the power steering fluid supply hose (Power Steering Fluid Supply Hose At Power Steering Pump) from the supply fitting on the power steering pump.
Let power steering fluid drain from the power steering fluid reservoir and power steering pump.
Install a cap on the open nipple of the power steering fluid reservoir to prevent power steering fluid from spilling when removing the power steering pump.
Remove the power steering fluid pressure hose (Pressure Hose At Power Steering Pump) from the pressure fitting on the power steering pump.
Let remaining power steering fluid drain from the power steering pump.
Loosen the lock-nut (Drive Belt Tensioner Lock-Nut And Adjustment Bolt) on the front of the pulley for the serpentine drive belt tensioner.
Using the adjustment bolt (Drive Belt Tensioner Lock-Nut And Adjustment Bolt) remove the tension from the drive belt for the power steering pump.
Remove the drive belt from the power steering pump pulley.
NOTE: Access for the power steering pump mounting bolts is through the holes in the face of the power steering pump pulley.
Remove the 3 bolts attaching the power steering pump to the power steering pump mounting bracket.
Remove the power steering pump from the engine. The power steering pump and pulley are removed as an assembly from the engine. The power steering pump is removed from the bottom of the engine between the radiator lower support and the cradle (Power Steering Pump Remove/Install).
Transfer the required parts from the removed power steering pump to the replacement power steering pump. See Disassembly and Assembly in this section.
