Chrysler Repair: 2001 sebring lxi headlight assembly removal, sebring lxi, grommet

Question
how are you roland,

I need to replace my passenger side headlight assembly for inspection because it is cloudy.. Before I order a new one do you know how to change it out? Is it a difficult job? Any help is greatly appreciated as always.

Thanks

Fran

Answer
Hi Fran,
I assume that you have the sedan model, not the convertible, correct?
The '00 manual I have shows there to be 4 fasteners: one screw that is on its top near the inside edge of the housing and it retains a  flange which is resting on the top of the radiator closure panel, apparently; then there are 2 screws on the back side of the unit, one in-board and one out-board, and finally at the far out-board end there is a grommet which may not be securing the unit but merely holding it in position. So try removing the three I described and then remove it.
Roland