Chrysler Repair: rear hub replacement: LH, caliper brake, chrysler concorde

Question
how do i replace my rear hub bearing on my chrysler concorde lx 2.7....and how many parts are required...thankyou very much

Answer
Hi Robert,
I was wondering if you solved the rear hub exchange, or if you still needed some help?
Use the 'thank/rate' tab below to get back to me if so. And while you are there if you would consider entering a 'yes' where you see the question about a "nomination of me for expert of the month" I would be most appreciative. Thanks in advance.




Hi Robert,
I check the '98 manual and it appears to be very straightforward.
Jack up and put on stand
Remove wheel
Remove caliper brake
Remove brake disc
Remove cotter key, nut and washer
Remove hub and bearing
Nothing is offered about the brearing and race but I assume it
will tap out as usual.
When installing tighten stub shaft nut to 124 foot-pounds
Tighten caliper to 16 foot pounds
Roland
PS Sorry for the delay. Your question just appeared in the "pool" to which it was referred, and I just found it.