Chrysler Repair: 99 chrysler town and country, chrysler town and country, leak detection

Question
a diagram showing the LPD leak detection pump so the check engine light will go off

Answer
LEAK DETECTION PUMP REPLACEMENT
REMOVAL
The Leak Detection Pump (LDP) is located under the driver's side in the cast cradle under the steering gear Leak Detection Pump

Raise and support vehicle on a hoist.
Push locking tab on connector to unlock Leak Detection Pump Connector Lock
Push down on connector latch and pull connector from pump.
Remove hoses.
Remove bolts holding LDP and bracket to cradle.
Remove bracket from LDP.
INSTALLATION
Install LDP to bracket.
Install LDP and bracket to cradle. Torque bolts to 9.5-14 N·m (85-125 in. lbs.) Before installing hoses to LDP, make sure they are not cracked or split. If a hose leaks, it will cause the Check Engine Lamp to illuminate.
Install hoses to LDP.
Plug electrical connector into LDP.
Push connector locking tab into place.
Using DRB scan tool, verify proper operation of LDP