Chrysler Repair: 2001 chryslr grand voyager, negative battery cable, throttle position sensor

Question
hi kevin, having problems getting a diagnosis with my GV,cutting out at low revs,eg turning into a driveway,rev counter "wobbling" at low revs.serviced recently no probs detected. any ideas?

Answer
give this a shot  any check engine light?

SUBJECT:
Engine Sag/Hesitation And/Or Closed Throttle Start Stall
OVERVIEW:
This bulletin involves replacing the Throttle Position Sensor (TPS).
MODELS:
2001 - **2002** (RS) Caravan/Voyager/Town & Country
2001 - **2002** (RG) Chrysler Voyager (International Market)
NOTE: **THIS BULLETIN APPLIES TO VEHICLES EQUIPPED WITH A 3.3L OR 3.8L
ENGINE AND BUILT BEFORE OCTOBER 01, 2001 (MDH 1001XX).**
SYMPTOM/CONDITION:
Engine hesitation/sag, closed throttle start/stall, and/or Diagnostic Trouble
Code (DTC) P0123 – “Throttle Position Sensor Voltage High”. May be more
prevalent in cold temperatures below 0 C. (32 F.).
DIAGNOSIS:
If no DTC’s are present or DTC P0123 is present, perform the Repair Procedure.
If other DTC’s are present further diagnosis is required.
PARTS REQUIRED:
Qty. Part No. Description
1 04686360AB Sensor, Throttle Position
REPAIR PROCEDURE:
1. Disconnect the negative battery cable.
2. Remove the electrical connector from the Inlet Air Temperature Sensor.
3. Remove the air cleaner box lid. Remove hose from throttle body.
4. Disconnect the electrical connector at the TPS.
5. Disconnect the electrical connector at the Idle Air Control (IAC).
6. Remove the three (3) TPS mounting bolts and TPS.
7. Reverse the previous steps to install new TPS, p/n 04686360.