Chrysler Repair: Replace a bulb in chrysler 2002 300M, pin fasteners, hood latch

Question
How do I replace a headlight bulb in a  chrysler 2002 300M

Answer
REMOVAL
NOTE: Some moisture accumulation inside a vented headlamp unit is normal. Moisture will vent from tubes or vents located on the back of the unit. This normal condition will appear as a fogging on the inside of the headlamp lens (similar to the fog that sometimes appears on the inside of the windshield). This moisture may be removed by activating the headlamps on high beam for 15 minutes.

If water droplets larger than 1 mm in size have accumulated on the inside of the headlamp lens, the headlamp unit should be replaced.


CONCORDE/300M
Release hood latch and open hood.
Disconnect and isolate the battery negative remote cable.
Remove the one bolt retaining the washer bottle filler neck and move aside.
Remove the two bolts retaining the speed control servo and move aside.
Remove fasteners to upper radiator crossmember:
Two jack screws on each side.
Three crossmember retaining bolts on each side.
Three push pin fasteners across top of grille.
Gently pry back grille and remove the two bolts to front crossmember. This will allow you to move the crossmember forward, pivoting at the radiator grille, to access the headlamp unit.
NOTE: Once the crossmember is loose, take care not to scratch the fenders.

Maneuver the headlamp unit to remove from behind fascia. Gentle prying of fascia may be needed to clear it enough to remove the headlamp unit.
Disconnect the lamp connectors and transfer lamps if replacing unit.
INTREPID
Release hood latch and open hood.
Disconnect and isolate the battery negative cable.
Remove jackscrews attaching headlamp to body (Headlamp Housing – Intrepid).
Remove headlamp from body.
Disconnect wire connector from headlamp and parking, side marker, and turn signal lamps.
Remove headlamp housing from vehicle.