Chrysler Repair: 1996 town and country chrystler, power window regulator, screw heads

Question
how do you re place the driver side window regulator and motor

Answer
FRONT DOOR WINDOW REGULATOR
REMOVAL
Remove door trim panel and water shield.
Remove door glass retaining clips and allow glass to rest on bottom of door.
Disengage wire connector from power window motor, if equipped. Refer to Power Windows, for procedure information.
Loosen screws holding front and rear window guide rails to inner door panel Front Door Manual Window Regulator
Separate screw heads on guide rails from key hole slots in inner door panel.
Loosen screws holding regulator to inner door panel.
Remove regulator from inner door panel.
Extract rear guide rail through inner door panel rear access hole Front Door Power Window Regulator
Extract front guide rail through front access hole.
INSTALLATION
Insert front guide rail through front access hole.
Insert rear guide rail through rear access hole.
Place window regulator in position on inner door panel.
Place screw heads on guide rails in position through key hole slots in inner door panel.
Tighten screws to hold front and rear guide rails to inner door panel.
Engage wire connector into power window motor, if equipped.
Install door glass.
Verify door glass alignment and operation.
Install water shield and door trim panel.