Chrysler Repair: EGR Valve location on a 1998 Chrysler Cirrus, gasket surfaces, transmission control module tcm

Question
Where is the egr valve located on a 1998 chysler cirrus lxi v6?

Answer
EGR VALVE AND TRANSDUCER - 2.5L
The EGR valve attaches to the front exhaust manifold. The transducer/solenoid attach to the front cylinder head.

REMOVAL
Disconnect vacuum supply from solenoid.
Disconnect electrical connector from solenoid.
Remove screws holding transducer to bracket.
Remove screws holding Transmission Control Module (TCM) to bracket TCM Removal Swing TCM up to allow access to EGR screws EGR Removal
Remove screws holding EGR tube.
Remove EGR valve mounting screws. Remove EGR valve and transducer.
Clean gasket surfaces. Discard old gaskets. If necessary, clean EGR passages.
INSTALLATION
Loosely install EGR valve with new gaskets.
Finger tighten EGR tube fasteners.
Tighten EGR tube fasteners to 11 N·m (95 in. lbs.) torque.
Tightening EGR valve mounting screws to 22 N·m (200 in. lbs.) torque.
Install transducer to bracket.
Connect vacuum supply to solenoid.
Attach electrical connector to solenoid