Dodge Repair: 03 dodge intrepid ignition cylinder and cylinder housing, torx head screws, electronic control modules

Question
Hello Kelvin,

My car was stolen and then recovered, but they broke the ignition cylinder and the cylinder housing. I am trying to replace them myself. Insurance company won't pay for it.  Can't afford a mech. Thank you!

Answer
go buy the key cly and have a lock smith re tumble the key for u  because u wont have the tumblers and able to use the old ones do to it being stolen.

REMOVAL
Disconnect remote battery ground cable at right strut tower and isolate.
Remove tilt lever, upper and lower steering column shrouds. (Refer to 19 - STEERING/COLUMN/LOWER SHROUD - REMOVAL)
If equipped with Sentry Key Imobilizer System, remove SKIM. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES/SENTRY KEY IMMOBILIZER MODULE - REMOVAL)
Remove and discard shift interlock cassette.
Remove nut securing wiring harness in place on left side of column.
Remove two multifunction switch mounting screws (Multi-Function Switch).
Lift off multifunction switch, then disconnect two wiring connectors and remove switch.
Remove two torx-head screws securing ignition switch in place (Ignition Switch Mounting Screws). Remove switch from column. allow switch to hang by wiring harness.
Remove two torx head screws securing lock cylinder housing to column (Lock Cylinder Housing Mounting).
Remove lock cylinder housing from steering column.