Dodge Repair: 1999 durango wheel hub removal, wheel hub, cotter pin

Question
I am unable to remove the wheel hub assembly from the spindle. Front brakes are not ABS. I have been beating on the triangular flange, but it will not budge. The axle spindle moves freely inside the hub. All bolts, brakes, discs, ect. have been removed. This is a 4x4 SLT front drivers side. Do you have any suggestions ? Thanks,Ang

Answer
HUB/BEARING
REMOVAL
Raise and support vehicle.
Remove wheel and tire assembly.
Remove axle nut.
Remove ABS wheel speed sensor if equipped, Refer torakes.
Remove the brake caliper and rotor, Refer torakes.
Remove hub/bearing mounting bolts from the steering knuckle Hub/Bearing
Slid hub/bearing out of the steering knuckle and off the axle
INSTALLATION
Install the hub/bearing into the steering knuckle and tighten the bolts to 166 N·m (123 ft. lbs.)
Install the brake rotor and caliper.
Install ABS wheel speed sensor if equipped.
Install axle nut and tighten to 235 N·m (173 ft. lbs.) and install cotter pin.
Install wheel and tire assembly.
Remove support and lower vehicle.