Dodge Repair: 96 Ram power window switch access, power window switch, switch connectors

Question
I need to replace the power window switch on my '96 ram truck.  How do I remove the plastic cover to gain access without damaging the cover or whatever clips might be holding it?

Answer
POWER WINDOW SWITCH
Disconnect and isolate the battery negative cable.
Remove the two screws in the door pull cup and remove the cup Door Pull Cup Remove/Install - Typical
Remove power window and lock switches by reaching through the door pull cup opening and depressing the switch bezel rear retaining tab Switch Bezel Rear Retaining Tab -Typical
Pull the rear of the switch bezel up and away from the door trim panel.
Unplug the wiring connectors from the switches Door Switch Connectors - Typical
Reverse the removal procedures to install. Install the switch bezel to the door trim panel by inserting the front of the bezel into trim panel opening, then push down on the rear of the bezel until the retaining tab snaps into place.