Ford Repair: 96 frrd tarus, rusty water, casting sand

Question
96 Ford Tarus
"My car is leaking Rusty water.I put it on ramps and it looks like its coming out between.Moter and Trany.I suspect a freez plug.Do you know how to get to it.Or do i have to pull flippin moter to get at it.Can you tell me how hard a task this is going to be.Or do you think it might be somthing else that may be causing this spu-ing of rusty water.Thanks in advance.Can you tell me where the freez plugs are located on this Model it has stock moter Diana";  

Answer
Hello and thanks for the question...I'll try to help.
 No, don't pull the motor. You have the pleasure of pulling the transmission, replacing the freeze plugs, re-installing the tranny, and then get an alignment. The freeze plug are getting pitted from the casting sand left over from the making of the engine block. It is a huge mess to do because, after the sub-frame and transmission are out, you have to flush the entire system of coolant and water, with new clean water in an attempt to remove the debris from the engine.
Use this link to guide you:

http://www.autozone.com/servlet/UiBroker?ForwardPage=/az/cds/en_us/0900823d/80/1...

Hope this helps,
Erik