Jeep Repair: Fan switch, negative battery cable, jeep cherokee

Question
The fan switch on my 1996 jeep Cherokee has broken.  I can't turn it up or down anymore.  It's stuck on low, but other than heat/ac works fine.  Any advise for fixing this?  Do I have to take of the entire dash board to get in there or is there a partial panel that I am not seeing?

Thanks!

Answer
Hey Scott,

On your 96 you will need to remove the instrument panel bezel. Disconnect the negative battery cable, remove two screws above the spedo, the rest of the bezel snap fits. Remove the radio then the four mounting screws on the AC/ Heater control panel. There should be just enough slack in the cables to R&R the switch without disconnecting them. If you want a little more room to work you can disconnect the cables.

Hope this helps,

Kenji