Small Engines (Lawn Mowers, etc.): valve adjustment ohv, twin cylinder engines, hp briggs

Question
Hello I have a 6-hp Briggs ohv engine on a generator I purchased not running, I was able to get it to run by adjusting the valves.  I was wondering if you know the clearance level and the proper procedure for adjusting the two valves

Answer
Hello pparana25:

**I Do Not Use the Setting Called for by the OEMs. I have Found that the Following Works Best. Remove the Valve Cover (on the Dead Cylinder for Twin Cylinder Engines). Set the Cylinder you are Setting the Valves on to Top Dead Center (Both Rocker Arms will have Play in them when the Engine is at TDC) on the Compression Stroke When Setting the Valve Clearance. Now Loosen the Valve Adjuster Locks and Set the Intake Valve Clearance to .004in -.006in and the Exhaust to .007in - .009in. I have had Better Performance Out of the Mowers and Less Burnt Valves Using these Settings. Be Sure the Piston is at TDC on the Compression Stroke.**  You can View a Breakdown/IPL of the Unit at this Site Addy; http://www.briggsandstratton.com/maint_repair/manual_and_more/doclist.aspx?categ... and Enter the Model Numbers (XXXXXX) and Type Numbers (XXXX) in the Appropriate Boxes and Click GO. If you Hit a Snag or this Does Not Correct the Problem,  I am Here if You Require More Assistance. Hope this Helps. Let me Know What Happens, Please. May the All Mighty Bless You and Yours. Thanks.

Good Luck

Respectfully

John

PS: I am Allowed to Answer 10 Questions a Day. If you See I am Maxxed Out, then Try Submitting your Question at or Just After 8pm EST (US). My New Day Starts then. Thanks.

Respectfully

John