Small Engines (Lawn Mowers, etc.): trouble with briggs 16.5, twin cylinder engines, compression stroke

Question
i have a poulan with a 16.5 briggs model #31c707 it turns over
real slow and may stop turning for a min then turn real slow
again.i put a new battery in it,change the starter cleaned
all cable ends and made sure they were god and tight.you may get it to crank and when it does it runs good does not skip or cut up at all.please tell what you thank i should try next.

                        thanks gary umpleby

Answer
Hello Gary:

This has Become a Common Problem with the OHV Engines. You need to Reset the Valve Clearance. The Compression Release is Not Operating Properly and Resetting the Valve Clearance will Correct this Problem. **I Do Not Use the Setting Called for by the OEMs. I have Found that the Following Works Best. Remove the Valve Cover (on the Dead Cylinder for Twin Cylinder Engines). Set the Cylinder you are Setting the Valves on to Top Dead Center (Both Rocker Arms will have Play in them when the Engine is at TDC) When Setting the Valve Clearance. Now Loosen the Valve Adjuster Locks and Set the Intake Valve Clearance to .004in -.006in and the Exhaust to .007in - .009in. I have had Better Performance Out of the Mowers and Less Burnt Valves Using these Settings. Be Sure the Piston is at TDC on the Compression Stroke.**  You can View a Breakdown/IPL of the Unit at this Site Addy; http://www.briggsandstratton.com/maint_repair/manual_and_more/doclist.aspx?categ... and Enter the Model Numbers (31C707) and Type Numbers (XXXX) in the Appropriate Boxes and Click GO. If you Hit a Snag or this Does Not Correct the Problem,  I am Here if You Require More Assistance. Hope this Helps. Let me Know What Happens, Please. May the All Mighty Bless You and Yours. Thanks.

Good Luck

Respectfully

John

PS: I am Allowed to Answer 10 Questions a Day. If you See I am Maxxed Out, then Try Submitting your Question at or Just After 8pm EST (US). My New Day Starts then. Thanks.

Respectfully

John