Small Engines (Lawn Mowers, etc.): Small Engine Repair, recoil starter, slip knot

Question
I have a HSSK50 snowblower and the pull cord broke.  I took off the recoil starter assembly and found that the rope broke close to the end.  I took out the old rope and tied on the remaining part of the rope and coiled it up, bolted the recoil started back on and pulled the cord, but it did not retract back.  What am I doing wrong?

Answer
Hello James:

**If the Rope has Broken and the Spring is Good, then Remove the Blower Housing (metal engine cover and recoil Starter). Remove the Old Rope from the Recoil Pulley. Now Turn the Pulley in the Same Direction that the Pulley would Turn if the Rope was Turning it. Once the Pulley will Turn No More, then Reverse Direction 1 or 2 Turns and Thread the New Rope Through the Hole in the Center of the Pulley and Out the Hole in the Blower Housing. Pull the Rope Through Until it is Tight Against the Pulley. Now Tie a Slip Knot in the Rope to Hold the Pulley in Place While the Handle is Attached to the Rope. Once the Handle is Attached, Release the Slip Knot and the Rope Should Retract Into the Housing. Reassemble the Blower Housing Onto the Engine.** If you Hit a Snag or this Does Not Correct the Problem,  I am Here if You Require More Assistance. Hope this Helps. Let me Know What Happens, Please. May the All Mighty Bless You and Yours. Thanks.

Good Luck

Respectfully

John

PS: I am Allowed to Answer 10 Questions a Day. If you See I am Maxxed Out, then Try Submitting your Question at or Just After 8pm EST (US). My New Day Starts then. Thanks.

Respectfully

John