QuestionJohn, I have a 20 some year old Murray lawn tractor, Model: 8-36508X92, date of mfg: 0623, with a 11 HP B&S engine, 36"cut. It has set idle for about 1 1/2 years, but ran great before that. Now, it won't start. It turns over, but the spark plug won't fire, no spark. Wires seem OK and I've replaced spark plug, fuel filter, air filter, and battery. Any suggestions?
AnswerHello Ron:
Having Set for So Long, you NEED to Do the Following in Order to Get the Full Satisfaction of Using the Mower Without Problems. 1- Remove, Disassemble and Soak the Carburetor Overnight in Carburetor Cleaner (I Use Gunk). I have Found that Most People can Use a Breakdown/IPL and Disassemble the Carburetor Enough for Proper Cleaning. You Only have to Remove the Bowl, Float Pin, Float and Needle Valve and Any Adjustment Screws that Go Into the Carburetor Body. The Welch Plugs Do Not have to be Removed. Then Soak the Carburetor Body and Parts in a 1 Gallon Can of Gunk Carburetor Cleaner Overnight. The Can has a Parts Tray Inside it for the Small Parts. Once the Carburetor and Parts are in the Cleaner, you can Replace the Lid for Safety and to Prevent Accidental Spillage. Then Blow Out the Passages with Compressed Air. Install New Parts if Required. You can View a Breakdown/IPL of this Engine at this Site Addy, http://www.smallenginepartswarehouse.com/parts.asp and Select the Shop Online Parts Look Up. Then Select the Model Tab. Then Select the OEM and Enter the Model and Type Numbers. Then Double Click on the Model in the Results Area. Now you can Select the Section of the Engine you Wish to View. 2- Diagnostic for the No Fire at the Plug. Remove the Spark Plug. Wrap a Wire Around the Threads and Attach the Other End of the Wire to the Engine Block Turn the Engine and See if the Plug Fires. If No, then Disconnect the Shut Off Wire at the Control Bracket First, Check for Fire at the Plug. If Still No Fire at the Plug; Then Disconnect the Shut Off Wire at the Coil (usually requires removal of the blower housing) and Check for Fire at the Plug. If No Fire at the Plug , then the Coil/Ign Module is Bad. The Coil/Ign Module to Flywheel Gap is .020in. On Some Model JD Engines, there is a Igniter that Goes Bad and Not the Coil. The Igniter is the Same as an Ignition Module. If the Plug Fires at Anytime During these 2 Checks, then a Safety Switch or Wire May be the Problem. Yes the Engine will Turn Even with a Bad Safety Switch. The Blade Safety is Usually the Cause of this. The Starter Turns and The Engine Doesn't Fire is an Indication of a Bad Coil/Ign Module or a Faulty Blade Safety Switch. The Clutch Safety Prevents the Starter from Engaging so the Mower Does Not Move when the Starter Turns the Engine. The Seat Safety is Designed to Stop the Engine if the Blades are Engaged or the Clutch Safety is Not Engaged when you Leave the Seat. 3- Use Spray Lubrication and Lubricate ALL the Pivot Points on the Mower. Grease Any Fittings. 4- Make Sure the Tank is Free of Rust and Water. Doing this Will Minimize the Trouble you will have with the Mower. Hope this Helps. I am Here if You Require More Assistance. Let me Know What Happens, Please. Thanks.
Good Luck
Respectfully
John
PS: I am Allowed to Answer 10 Questions a Day. If you See I am Maxxed Out, then Try Submitting your Question at or Just After 9pm EST (US). My New Day Starts then. Thanks.
Respectfully
John
