Small Engines (Lawn Mowers, etc.): Murray riding mower wont start, murray riding mower, switch jumper

Question
Have a Murray 16 hp 42 in cut riding mower.  Won't start with ignition switch.  Replaced switch and still won't start.  Can jump start at the solenoid so I know it runs.  The seat safety switch is disconnected.  I have tried with it connected and that does not help. What else can I check.

Answer
Hello Bobby:

Use your Jumper Cable Set and Attach the Positive Lead Onto the Positive Post of the Battery (make sure the Battery is Fully Charged or is a New Battery). Now Firmly Touch the Large Post on the Starter. If the Starter Does Not Turn, then the Starter is Bad. If the Starter Turns the Engine Properly, Then Check the Solenoid. Firmly Touch the Small Post at the Base of the Solenoid that has the Ign Wire Attached to it. If The Starter Does Not Turn and the Solenoid Clicks, Then the Solenoid is Bad. PLEASE REMEMBER THAT THE INSTRUCTIONS FOR CHECKING THE SAFETY SWITCHES IS JUST THAT!!! FOR CHECKING ONLY. I NEVER Suggest a Mower be Operated with a Safety Device or Switch Disconnected or Bypassed. Now. On Some Model Mowers you can Simply Unplug the Safety Switch from the Harness. On Other Models you have to Place a Jumper Wire Between the Harness Terminals (on the 4 Post Switch Jumper from Same Color Wire to Same Color Wire). Check the Clutch/Break and the Blade/PTO Safety Switches First. Check the Seat Safety Last. Usually the Seat Safety is Not in the System for Starting the Engine. Just to Ensure Someone is in the Seat when Engaging the Transaxle and/or Blades. Hope this Helps. I am Here if You Require More Assistance. Let me Know What Happens, Please. Thanks.

Good Luck

Respectfully

John

PS: I am Allowed to Answer 10 Questions a Day. If you See I am Maxxed Out, then Try Submitting your Question at or Just After 9pm EST (US). My New Day Starts then. Thanks.

Respectfully

John