QuestionQUESTION: I switched it to defrost and went to turn knob to the heat setting. The knob seemed to stick so i gave a little sturdier push and something broke loose. It only stays on cold air now. Is this something I can fix on my on. I am assuming either a control arm inside the dash has popped loose or a belt that whitches from cold to hot. Thanks for any help or advice.
ANSWER: Does it have automatic climate control or manual system?
---------- FOLLOW-UP ----------
QUESTION: A knob (blue left side) cold, (red right side) hot.
ANSWER: Ok, you'll need to remove the control panel and check to see if the cables are still attached, sometimes the control levers can break or a cable can come off.
---------- FOLLOW-UP ----------
QUESTION: I am very handy and have no issues with going into the dash. With that said, do you have a step by step or can you provide a snapshot of what I am getting into?
AnswerHello, pull the round control knobs off, there ai a screw or two under the knobs, remove thos and the faceplate can be pulled off, you'll see the bolts for the radio unit , remove it then remove the screws for the control panel, I'll see if I can locate a diagram and post it later.
