Toyota Repair: failed inspection, connecting rod bearings, toyota camry

Question
-------------------------
Thanks  Your your help Ted , But what about the 3 sensors , will that EFI fuse reset them too or do I have to replace all the 3 fuses.Is is true that the sensors may adjust itself after I drive 500 miles when i changed the con rod bearings. Thanks again Ted. So long Larry
Followup To
Question -
Hi Ted, I just replaced the connecting rod bearings on my 2000 toyota Camry CE and took the car for inspection a few days after but failed because of bad knock sensor, speed sensor and cam position sensor.What should i do? drive the car and sensors will reset itself or replace them. Thanks Larry
Answer -
I'm not sure if this will work but you can give it a try, open the fuse box under the hood and remove the EFI fuse, wait for ten seconds and put it back in and see if the check engine light stays off.  

Answer
Removing the efi fuse or disconnecting the battery will erase the trouble codes stored in the computer, it will not repair a malfunctioning input sensor, some trouble codes can't be cleared by removing power to the computer, give this a try and see if the check engine light goes off.