Car Alarms: 1995 Acura Legend Car Alarm, valet mode, alarmtek

Question
QUESTION: After disconnecting the battery to clean the terminals, the alarm goes off & cannot start car.

ANSWER: Please be more descriptive if possible.

"GOING OFF?"

I need to determine whether it's a factory alarm
issue or, if it's an aftermarket system you are
dealing with.

Is it: Headlights flashing, car horn honking
and a worded SECURITY" light in the dash flashing?
(doubtfull since none of the notes show this
car as having a factory alarm system)=FACTORY

Or,

is it: flashing parking lights,
an LED in the dash area, and a siren
going off?= AFTER MARKET

Let me know more on this to better
advise you on a course of action
to take.

Best Regards,

Robert Martin
CEO/ALARMTEK
CARALARMMAN.com

---------- FOLLOW-UP ----------

QUESTION: park lights flash and siren alarms goes off factory alarm system

Answer
No sorry, if a siren is involved, NOT factory.
Please read that again.

Seems the system is reset, and needs
to be done again.

Probably when, or if it lost power.

Right, Ok, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, press and hold in the valet/overide
button, found under the dash area, usually to the left
of the leg, drilled into a plactic panel.
Might even be part of an on glass antenna
in the widshield if it's a remote starter,
until the installed LED (the blinking light)
in your dash area goes off, and the siren chirps twice.
(Your valet switch might be the toggle (on/off) type.
in this case, key on, flip switch in oposite direction,
key off.)

This should reset the alarm and allow you to
go on your way.

Just Repeat these steps to place it
back to valet mode.

That should do it.

Good luck.

ALARMTEK