Car Alarms: Factory installed alarm, mobile mechanic, subaru forester

Question
I have a 1998 Subaru Forester, I had to change the alternator. In doing so the factory alarm set. I can not start the car. This happened once before and a mobile mechanic came and went under the dash and pressed something and the card turned over.I can not find the button, I have found two wires connected to something that seems to have had something screwed onto it, which I believe was the button. can you help me?

Answer
Ok then, get over to the local car alarm shop,
or even a Best Buys will
have a valet switch that will fit for your
alarm.

In the mean time, cut off the switch part,
leaving the 2 wires that wer connected, free.

Then twist together, turn on the ignition,
hold both wires to ground until the siren chirps.

That should reset and place the alarm into
over ride for now. Nothing accept the keyless entry
if installed will operate until you repeat the
same steps.

Then get a new switch and you're all set.

Have a good evening.
Let me know if you were
successful.

ALARMTEK
CARALARMZ.COM