QuestionIt is a 1/2" and I do not know what the torque is -------------------------------------------
The text above is a follow-up to ...
-----Question-----
what is the torque setting for the plate with two bolts that hold down the protuding injector of a 1971international cummins 290
-------------------------------------------
The text above is a follow-up to ...
-----Question-----
I took out the #1 injector and it is a protude the spring is above injector It was rebuilt the problem I have is that I do not know what are the torque expecifications for the little plate two bolts7/16 that hold the injector down in position to the head. One other question if the torque is 55-60inlbs what is it in FOOT/lbs do you know
-----Answer-----
You want find a torque wrench that will go that low probably.Just divide it by 12 for FTLBS which would be 4-5 ftlbs.
-----Answer-----
3/8" bolts torque to 25 FtLbs & 5/16" bolts torque to 156 InLbs.
Answer On that eng,you adjust valves & inj on same cyl.The mark A is now 1-6,B is 2-5, & C is 3-4.Valves are Int 0.016 & Exhaust is 0.029.The injector you torque to specs to bottom injector plunger.Then tighten the jam nut down.Adjust the Injector first,then the valves.
