Car Alarms: locating starter wire on 94 mazda protege?, valet mode, starter wire

Question
hello, i lost the keyless entery remote and suddenly my car alarm went off. I unpluged the speaker to eliminate the sound but now the starter kill is in effect. I would like to know how to locate the starter wire so i can eliminate the entire alarm. Any info would be very helpfull. Thank you.

Answer
It's an after market system
from your description.

To simply disarm it, locate and use the
valet/overide switch.

To start, look under the dash area for a button or,
a toggle switch. When you locate it, turn on the
ignition key, press and hold in the button (little
spring loaded micro button, red or black possibly)
until the alarm chirps 1 time. This should over ride
the system, and only the keyless entry part,
if installed, would still be operating.
The LED (light emiting diode) light in the dash
should also go on solid.=VALET/OVERIDE

This stops the alarm except for the keyless
entry if installed. The next step is to
either remove the alarm or, try to identify,
and get new remotes for it.

But once in Valet mode, it will allow the car
to start and operate like there was no
alarm at all. Repeat steps to put into user
mode. Re attatch the siren.

Let me know how it goes.

ALARMTEK
CARALARMMAN.COM