Car Alarms: 1998 toyta camry car alarm, dash area, starter wire

Question
hi, i have a 1998 toytoa camry 4 cilender. the car was working fine, and i tried to turn it on and the alarm went off car wouldnt start. so i got out and tried loking and unlocking the door which it says to do so in manuel, it wouldnt turn off and about 45 seconds later so i opened the door and the alarm trigered again how do i turn it off?

Answer
This is an aftermarket
system with starter kill. Ok, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, press and hold in the valet/overide
button, found under the dash area,
until the installed LED (the blinking light)
in your dash area goes on solid, and the siren chirps once.
(Your valet switch might be the toggle (on/off) type.
in this case, key on, flip switch in opposite direction,
key off.)

This should reset the alarm, and reset
the grounded relay on the starter wire,
allowing you to start it. At this point,
the only thing working would be
keyless entry from the alarm,
if it came equipped.

Just Repeat these steps to place it
back to usable armed mode.

That should do it.
If you want to remove it at this point,
take it to your neighborhood installer
for this, or buy the wiring chart (www.wirewerx.com)
for the vehicle, and reverse engineer it wire
by wire, until safely removed.

If it does not work out this way,
you will have to replace the system
with one you know how to operate
and what to expect. Don't want to
get stuck in another bad situation.

Let me know what happens.

ALARMTEK
CARALARMSTORE.com