Car Alarms: door lock in ford f-150 1999, ford f 150, volt power

Question
I install a remote starter in my f-150 1999 auto.
all is ok but my doorlock/unlock isn't ok, I have 3 wires one pluged on the wire PINK/YELLOW, the other on the wire PINK/GREEN, in passenger kickpanel, NOW, THE WIRE RED (12VOLTS) WHERE I PLUG THIS WIRE? I PLUG IT ANYWHERE ON A 12 VOLTS IN THE CAR?

Thanks

Answer
There is no "pluging in" you would need to determine
which system you have. Non-keyless versions are 5 wire
reverse door locks located in the drivers door harness.

Keyless versions are negative trigger located in a gray molex plug to the right side of the steering column.

See www.mrinstall.com to see how to test door locks,
and also www.relayhelp.com to see the relay
setup for 5 wire reverse door locks, and for 3 wire
negative door locks.  

When powering the relays,
go to the key switch, where you did the 12 volt power
and the ignition wiring. Use the same 12 volt constant there.

ALARMTEK
WIREWERX.com