Car Alarms: Disarming a factory toyota alarm, valet mode, toyota alarm

Question
Just bought a new 04 Toyota Tacoma truck with a factory installed pursuit model 9232a (name on manual) alarm.
Question is how can I disable it or go into valet mode or turn off the chirps. In the manual it says to use the valet/override switch on the transmitter. Or, manualy override by entering the factory code.

The transmitter only has lock/unlock/panic buttons.
Where are you supposed to enter the factory code - somewhere on the "brain" part.

Thanks for help

scott trembley

Answer
Ok, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, press and hold in the valet/overide
button, found under the dash area,
until the installed LED (the blinking light)
in your dash area comes on solid.
(Your valet switch might be the toggle (on/off) type.
in this case, key on, flip switch in oposite direction,
key off.)

This should be valet. This overides
the starter kill relay in the alarm harness,
and returns the car back to disarmed mode.

The only thing that will work now on your system,
is the keyless entry if installed.

Just Repeat these steps to rearm your system.

That should do it.
If you want to remove it at this point,
take it to your neighborhood installer
for this, or buy the wiring chart for
the vehicle, and reverse engineer it wire
by wire, until it's safely removed.

Let me know what happens.

ALARMTEK
STARTERDISABLE.com