Car Alarms: How to reset my alarm mode?, valet mode, alarm mode

Question
Hi i disconnected my alarm, rattler 310d, from my vehicle and when i reinstalled it, the alarm works but it goes off when i turn my key in the ignition. i dont have a valet mode switch wired on the alarm so, i disconnected the yellow wire connected to my ignition switch and my car works fine.

b4 all the problems my horn would beep twice to deactivate and once to activate. my alarms red light on the dash wouldnt blink when the alarms off and would blink when i activate it.
now my alarm beeps 4 times to deactivate and the red light blinks twices every second while deactivated. and the alarm beeps once while activated but the light blinks 3 times a second.

my question is how to i set things back to narmal?   im not sure if my car battery is draining more in this mode thats why. cause the red light always blinks now.

Answer
I believe you asked this before. I know as much
now as I did before. Without a valet button or
switch, I have no idea how to reset this system.

You need to contact DEI www.directed.com
and ask them about Rattler. I don't sell or
install/support it here.

Good luck with it.

ALARMTEEK