Chrysler Repair: Removal of 96 Voyager instrument cluster, instrument cluster, steering column

Question
QUESTION: Kevin, can you tell me where I can access removal instructions for a 96 Voyager instrument cluster?  I need to check the connections to the cluster and don't see how it's done.  Thank you.  John

ANSWER: Can you tell me if the transmission indicator is electronic or mechanical? That effects the removal procedure.
Roland

---------- FOLLOW-UP ----------

QUESTION: Kevin, the transmission indicator is electronic.  The fascia has a curved contour as opposed to a rectangular one.  Thank you for your help.

Answer
Hi John,
Remove the steering column cover (I believe this is the upper 'shroud' which is held im place from underneath the column by 3 screws in the lower shroud).
Remove the cluster bezel:
remove the left end-cap of the dash
remove screw at left end of bezel and remove headlamp switch
remove screw holding bezel to instrument panel on each side of steering column
remove screws on the underside of the bezel just above the cluster
disconnect clip that holds cluster bezel to panel from above right vent louver
Separate bezel from instrument panel.
Disconnect wires from back of bezel
Remove screws holding the cluster to the panel
Rotate top of cluster rearward
Remove cluster, disconnect wires from rear

Reverse procedure to install
be careful not to stress the vent louvers when installing clips

Roland

PS: I found your question in the 'pool' to which Kevin had referred it. Please 'rate' my answer and where you see the question about whether to nominata me as 'volunteer of the month' please consider whether this is warranted. Thank you.

Roland