QuestionI would like to put a RV backup camera on the back of my truck's top so I can see to hook up my 5th wheel camper on my monitor I use for my 5th wheel camera. How do I get the interior of the roof apart so I can run the wires to the front of the truck?
AnswerREMOVAL
NOTE: Headliner for Quad Cab model shown. Regular cab similar.
1. On Mega Cab models, remove the front seats, (Refer to 23 - BODY/SEATS/SEAT - FRONT - REMOVAL) .
2. Remove the A-pillar trim panels (Refer to 23 - BODY/INTERIOR/A-PILLAR TRIM - REMOVAL) .
3. Remove the upper B-pillar trim panels (Refer to 23 - BODY/INTERIOR/B-PILLAR UPPER TRIM - REMOVAL) .
4. On Quad Cab models, remove the upper C-pillar trim panels (Refer to 23 - BODY/INTERIOR/C-PILLAR TRIM - REMOVAL) .
5. Disconnect the wire harness connector (1) located at the left A-pillar from the headliner wire harness (2).
6. Disconnect the headliner wire harness connector (3) from the inside rear view mirror.
7. Remove the overhead console (Refer to 8 - ELECTRICAL/OVERHEAD CONSOLE - REMOVAL) .
8. Remove the sun visors (4) (Refer to 23 - BODY/INTERIOR/SUN VISOR - REMOVAL) .
9. Remove the sun visor supports (5) (Refer to 23 - BODY/INTERIOR/SUN VISOR SUPPORT - REMOVAL) .
10. Remove the dome lamp (6) (Refer to 8 - ELECTRICAL/LAMPS/LIGHTING - INTERIOR/DOME LAMP - REMOVAL) .
11. Remove the two coat hooks (7) (Refer to 23 - BODY/INTERIOR/COAT HOOK - REMOVAL) .
12. Lower the rear of the headliner (9) downward from the roof panel (10) and disconnect the headliner wire harness connector (8) from the center high mounted stop lamp.
13. Lower the front of the headliner downward and remove the headliner through the passenger door opening.
