Land Rover Repair: o3 range rover, wheel arch, mounting brackets

Question
how do i connect a after market horn? where are the horn harnesses located?

Answer
Hi Tony,

here's what I found:

HORN

Remove
1. Raise RH front of vehicle and support on stand.

WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

2. Remove 5 scrivets and 3 screws securing RH wheel arch extension to splash shield and bumper.
3. Remove front wheel arch extension.
4. Remove bolt securing horn assembly to armature. Remove horns.
5. Disconnect horn multiplugs.

NOTE: Do not carry out further dismantling if component is removed for access only.

6. Remove nuts securing horns to mounting brackets. Collect horns.

Refit
1. Position horns to mounting bracket, fit nuts and tighten to 10 Nm (7 lbf.ft).
2. Connect multiplugs.
3. Position horn assembly to armature, fit and tighten bolt to 10 Nm (7 lbf.ft).
4. Fit and secure wheel arch extension.
5. Lower vehicle.

Best of luck,

JohnMc