Small Engines (Lawn Mowers, etc.): Carburetor hook up, eager 1 engine, throttle control

Question
I have put in a repair kit for the carb. on my 1998 Sears lawnmower. It has an Eager-1 engine. I need to know how to hook up the throttle link and Govenor link to the plate on the top of the carburetor. Thank you for any information you can provide.

Answer
The solid rod hooks into the top hole on the gov. arm,You want the longest stright end in this arm,The bend area closest to the carb.,On the carb. is three holes put this rod in the hole closest the engine block but as far away from the gov. arm. The spring goes in the second hole down on the gov. arm,Make sure you dont twist the spring but on the throttle control there should be two holes on a arm sticking out towards the engine block put this rod in from the bottom so the hook end is on the top in the hole closest the block,This will ensure the two rods don't touch each other. Now look up under the throttle control and there should be a small screw facing you,This is the high speed adjuster screw it in to raise RPM screw out to lower.