Car Alarms: Ungo alarm, valet mode, dash area


Question
the alarm seemed turned off this morning as the blue flashing light inside my truck was not on & when clicking my remote nothing happened. I was able to open truck with key & power seemed to work fine. Started up truck & it died. Now it wont start. any suggestions?

Answer
Right,
Ok, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, press and hold in the valet/overide
button, found under the dash area, usually to the left
of the leg, drilled into a plactic panel,
until the installed LED (the blinking light)
in your dash area goes off, and the siren chirps twice.
(Your valet switch might be the toggle (on/off) type.
in this case, key on, flip switch in oposite direction,
key off.)

This should reset the alarm.

Just Repeat these steps to place it
back to valet mode.

That should do it.

Good hunting.

ALARMTEK