Chrysler Repair: replacing headlight bulbs, 2007 chrysler seabring, halogen bulbs

Question
How do I replace headlight bulb in a 2007 Chrysler Seabring

Answer
BULBS



HEADLAMP HIGH BEAMS

 
CAUTION:  Do not touch the glass of halogen bulbs with fingers or other possibly oily surface. Reduced bulb life will result.  


1. Disconnect and isolate battery negative cable.
2. Disconnect the headlamp bulb electrical connector.
3. Grasp the bulb (1) and twist counterclockwise.
4. Pull headlamp bulb (1) rearward and remove from front lamp unit.




HEADLAMP LOW BEAM DRIVER SIDE
1. Disconnect and isolate battery negative cable.
2. Loosen air intake housing and move aside.

Disconnect the air intake sensor connector.
Remove the one retaining bolt.
Pull up on air intake housing and move to side.
3. Unclip the power distribution center and lay off to the side.
4. Disconnect the headlamp bulb electrical connector.
5. Grasp rear of bulb and twist counterclockwise.
6. Pull headlamp bulb rearward and remove from front lamp unit.


HEADLAMP LOW BEAM PASSENGER SIDE
1. Disconnect and isolate battery negative cable.
2. Disconnect the headlamp bulb electrical connector.
3. Grasp rear of bulb and twist counterclockwise.
4. Pull headlamp bulb rearward and remove from front lamp unit.


TURN SIGNAL / SIDE MARKER

 
1. Disconnect and isolate battery negative cable.
2. Reach in through the opening in the front of the fender and disconnect the turn signal lamp electrical connector (1).
3. Twist the bulb socket (3) counterclockwise and pull rearward to remove.
4. Pull bulb from bulb socket (3).