Question1994, Mazda 626, 2.0L, 180,000. Recently it just died, had to replace the timing belt and coil. It now starts great and runs for a few minutes and then stalls. It will always start but not run after the engine warms up. Converter was also changed recently. I have run out of ideas.
AnswerHi Gail thanks for asking
This is hard to tell without any more detail but this sounds like a possible problem with the Idle air control motor , a mass air flow sensor, Throttle positiong sensor, or just a vacuum leak.
These are all common symptoms of a engine stalling out.
Good Luck
Chris P