Chrysler Repair: 98 Caravan Instrument Cluster, negative cable, body control module

Question
I read your post on the intermittent gauges on a 98 Caravan with the 3.0. I just bought one and I am pretty sure it has the "cold solder" issue because it works some of the time. It does not appear like the Body Control Module is the issue. How hard is it to get the cluster out and inspect it without cracking a bunch of the plastic? I'm fairly mechanical in nature, I just don't want to crack the plastic because of a hidden fastener or something.
Thanks,
Andy

Answer
INSTRUMENT CLUSTER BEZEL
REMOVAL
Disconnect and isolate the battery negative cable Battery Negative Cable
Remove Over Steering Column Bezel Removal and Installation in this section.
Remove over steering column bezel.
Remove left end cover.
Remove screw at left end of cluster bezel and headlamp switch.
Remove screws holding cluster bezel to instrument panel from each side of steering column.
Disconnect clip holding cluster bezel to instrument panel from above right vent louver.
Separate cluster bezel from instrument pane Instrument Cluster Bezel l
Disconnect wire connectors from back of the bezel.
INSTALLATION
Connect wire connectors into back of the bezel.
Place cluster bezel in position on instrument panel. Use care not to place hands on louvers.
Connect clips to hold cluster bezel to instrument panel. Use care not to add pressure on the A/C louvers to seat the cluster bezel clips.
Install screws to hold cluster bezel to instrument panel on each side of steering column.
Install screw at left end of cluster bezel and headlamp switch.
Install left end cover.
Install over steering column bezel.
Install lower steering column cover