Mazda Repair: 323 Stalls, mass air flow sensor, mass air flow

Question
I have a 92 323 that dies when coming to a stop. I have replaced the PVC valve, distributor cap / rotor, plugs and plug wires. Still no luck. Any ideas?

Answer
Hi W Mcmills thanks for asking
there are a couple things you will have to check, check for a vacuum leak anywhere on the engine, that will cause a stall situation. If this vehicle is equiped with a mass air flow sensor inspect that and measure its output, same goes with the idle air control motor, another big possibility is the EGR valve, if that is stuck full open it may cause the engine to stall. get back to me with results.
good luck
Chris P