Motorcycle Repair: No front brake, dyna lowrider, brake caliper

Question
After installing a new braided front brake line on my 2001 Dyna Lowrider, the front brake will not pressure up.  I have bled the line and I get fluid from the bleeder valve but the lever will  not harden up.  I had no brake problems prior to the installation of the braided line.  The line was replaced while installing a new handle bar.  The bike has 10,000 mile on it.  I'm stumped. Any ideas?  Thank you kindly.

Answer
Hi Jim.
use a EZ BLEED seringe to back bleed the caliper to the master cylinder, fill the EZ Bleed and install it on the bleed screw on the brake caliper and then loosen up the bleed screw and push the brake fluid into the master cylinder. when all bubbles are gone. tighten bleed screw and remove EZ bleeder. now put master cylinder top back on and pump brakes. make sure all banjo bolts are torqued and not leaking. JOHNNY  www.southsidesdyno.com